3
4
Parker Hannifin Corporation
|
Pump & Motor Division
|
Kings Mountain, NC
Parker Hannifin Corporation
|
Pump & Motor Division
|
Kings Mountain, NC
WARNING:
This product can expose you to chemicals including lead or DEHP which are known to the state of California to cause cancer,
birth defects, and other reproductive harm. www.p65warnings.ca.gov
WARNING:
This product can expose you to chemicals including lead or DEHP which are known to the state of California to cause cancer,
birth defects, and other reproductive harm. www.p65warnings.ca.gov
Catalog HY13-PMD500-SM/US
PGP/PGM 500 Series
Gear Pumps & Motors Service Manual
Tool List
Arbor press
Snap ring pliers
Awl
Prick punch
Clean, lintless cloths
Scale (1/32" or 1/64" graduations)
Deburring tool (an old file with cutting teeth ground off)
Small screw driver
Machinist’s hammer
Torque wrench
Soft hammer
Vise with 6" minimum opening
Medium grit carborundurn stone
Bar for lip seal installation
Seal removal tool (See A)
Special mylar sleeve (See B)
Oil and Grease
Special Mylar Sleeve
The special mylar sleeve is used to insert the drive shaft through the lip seal without damage. The drawing and chart
give details for making this special tool.
NOTE: Please see tool list for lip seal bar installation.
Pump/Motor
A
B
C
PGP/PGM 505
2.71"-3.190" 0.631"-0.634" 0.634"- 0.635"
PGP/PGM 511 2.940"-3.000" 0.690"-0.694" 0.698"-0.702"
B
Seal Removal Tool
Easily made from an old screw driver. Heat the tip and bend as shown. Grind the tip to fit the notch behind the shaft
seal.
A
1/4"
General Information
A Length
B
I.D.
C
O.D.
