Parker LCR Series, Product Manual

Page: 31 / 39

LCR22/LCR30 SERIES PRODUCT MANUAL__________________
31
WWW.PARKERMOTION.COM
PH: (724) - 861 - 8200
Replace belt
Run belt under drive pulley and into pocket of base. The use of screw driver /allen key can assiat into assuring the belt
enters the pocket in base and does not raise up into main body extrusion. Push belt through extrusion and use same
screw driver/allen key to assist in allowing belt to go under idler pulley and out the idler end.
Wrap the belt around the drive and idler pulleys and bring belt ends to carriage. Make sure the tension plates are fixed
as stated on previous page( pushed toward the base extrusion.) . Lay Belt teeth on carriage teeth as shown. Make sure to
achieve at least 5 teeth engament of belt on each side and then place/mount top of carriage to clamp belt utilizing the
Qty2 socket head fasteners..
LCR22 Bushing carriage employs clamping nuts and requires the belt be punched with 2.0mm hole.