Parker Airtek SMART CYCLE PLUS 80, Operator'S Manual

Page: 19 / 45

- 19 -
Do not pass air through the dryer until it is stabilized.
(Unit cycles 2 – 3 times)
10. With the dryer turned on from the control panel, and is stabilized, you can now introduce
compressed air to the dryer.
11. Check the automatic drain for proper operation. Drain should open at regular intervals based on
the drain control settings.
Clean Y-Strainer after the first 4 hours of operation. (If unit has float demand
drains there is no Y-Strainer, for larger unit only not 80 – 1200 SCFM)
12. Restart dryer using this procedure after maintenance, power outage or prolonged periods of
shutdown.
When Operating Dryer
1. Turn dryer On and Off at control panel.
2. Keep power to unit during off cycles.
3. Start dryer prior to allowing air flow through unit.
4. Clean condenser when necessary.
5. Keep ambient temperature under 95ºF (35ºC)
6. Keep inlet temperature under 100ºF (37.7ºC)
7. Keep inlet pressure above 100 PSI (8.6 bars)
8. Check and clean Y-strainer often (shut isolation valve off).
9. NEVER cycle dryer with air compressor.
Attention
!