Parker Airtek SMART CYCLE PLUS 80, Operator'S Manual

Page: 14 / 45

- 14 -
Main Display - System Shutdown Due To Critical Alarm

Alarm Description

Shutdown status
Critical Alarms
"DRYER OVERLOAD"
"BAD SENSOR SHUTDOWN"
"LOW SUCTION PRESSURE"
"HIGH DISCHARGE PRES."
"HIGH SUPERHEAT"
"EVAPORATOR FROZEN"
"EMERGENCY STOP"
"BAD PUMPDOWN"
"SYSTEM FAULT"
Press the ALARM key to reset all alarms
Press the RUN SELECT key to restart the dryer after an alarm
Note: if more than one alarm condition exists, then the top line of the display will automatically cycle
thru all active alarms.
Read System Parameters
Press the READ key to cycle thru the system parameter values

Parameter Description

Parameter Value
Dew Point Temp. 0 thru 200
o
F
Superheat Temp. 0 thru 100°F
Suction Temperature 0 thru 200
o
F
Suction Pressure 0 thru 600 psi
Discharge Pressure 0 thru 600 psi
Inlet Temperature 0 thru 200
o
F
Condenser Temperature 0 thru 200
o
F
Note: The parameter value will display “FAULT!” if the sensor input is invalid
Dew point
36°F
HIGH DISCHARGE PRES.
Alarm Shutdown
AUTO MODE (L)
Alarm Shutdown