Parker AC30 series, Safety & Quickstart Booklet

Page: 10 / 28

1-6 English
Cabling Bracket for Control & Main Cable
When bottom cover is removed you can install the cabling brackets, if required.
The cabling brackets are standard with C2 filtering products and can be obtained from Parker using the following
part numbers:
Power Wiring Connections
Feed the power supply and motor cables into the drive
under the cable clamps using the correct cable
entries, and connect to the power terminals. Tighten
all terminals to the correct tightening torque, refer to
the ‘Terminal Tightening Torques' table in the AC30
Product Manual, Chapter 4 ‘Installation’.
Note: Cable clamps and earthing brackets are
only supplied with a C2 EMC Filter kit (see previous page for part numbers),
see page 1-14 for motor termination details.
The part numbers for cabling brackets are:
Frame D – LA501935U001
Frame E – LA501935U002
Frame F – LA501935U003
Control cable
wiring bracket
Main cable
wiring bracket