TG-Filter_EN_01—2016
19
►
For ATEX-compliant filters:
Ensure conductivity, test and document it.
►
Check the housing for tightness.
TGS filters
Depending on its size, a filter housing can accommodate up to 10 filter elements.
The following description applies to a single filter element per housing, but
equally to several ones as well.
►
Make the same preparations as described in
section “Preparations” on page 17.
►
Unscrew and remove the nuts on the lower
housing.
►
Remove the lower housing or swing it aside.
►
Remove flat seal.
►
Unscrew and remove the filter element.
►
Insert a new filter element with O-ring and hand-
tighten the filter element.
►
Insert new flat seal.
►
Make sure the O-ring and the flat seal are properly
seated.
►
Assemble upper and lower housing and tighten
the screws again.
►
Close the manual drain valve again.
►
For ATEX-compliant filters:
Ensure conductivity, test and document it.
►
Check the housing for tightness.
