34
35
SLIDING MITRE GAUGE
SLIDING MITRE GAUGE
The mitre gauge slots into either of the inverted
‘T-slots’ that are on either side of the blade. The
adjustable face plate is held in the protractor base
with two wing nuts – loosen to adjust and then
tighten to secure.
2
FIT THE MITRE GAUGE
3
ADJUST THE MITRE GAUGE
To set the angle that you desire simply loosen the
red handle. Use the protractor scale and pointer to
set the gauge to the angle that you require. Once
the angle is set, tighten the red handle
The adjustable face plate is held in the protractor
base with two wing nuts – loosen to adjust and
then tighten to secure.
4
TIGHTEN THE MITRE GAUGE
1
THE MITRE GAUGE
The sliding mitre gauge can be repositioned as re-
quired and is fully adjustable.
NOTE:
The Mitre Gauge can be used either side of blade and runs in either of the two inverted 'T' slots
in the table top.
i
WARNING:
Conduct a 'dry run' with the machine disconnected from the mains supply to ensure that the
mitre guage slides passed the balde and blade guard without any interference.