Park TCL-110, Instructions Manual

Page: 22 / 22

TROUBLE SHOOTING
FAULT PROBABLE CAUSE SOLUTION
When switched on Plug is not well connected or electric Check plug, socket and fuses
the machine will socket is faulty
not start working
The main voltage is insufficient Check that the main voltage is
lower than minimum requirement adequate
The pump is blocked Clean
Thermal safety switch has tripped Switch off the unit and let the engine
cool for a few minutes
Leave the lance open
Fluctuating The pump sucks air Check that hoses and connections
pressure are airtight
Valves are dirty, worn out or stuck
Clean and replace or refer to dealer
Pump seals worn out
Water leaking from Seals worn out Check and replace or refer to dealer
the pump
The engine stops Thermal safety switch has tripped Check that the main voltage
suddenly due to overheating corresponds to specifications.
Switch off the unit and let it cool for
a few minutes
The pump does not Water inlet filter is clogged Clean the water inlet filter
reach the necessary Check that all supply connections
pressure Pump sucking air from connections or are tight
hoses
Suction/delivery valves are clogged Check that the water feeding hose is
or worn out not leaking. Clean or replace valve
Unloaded valve is stuck Loosen and re-tight regulation
screw
Lance nozzle incorrect or worn out Check and/or replace
TEXAS ANDREAS PETERSEN A/S
Knullen 2 • DK-5260 Odense S
Ph. +45 6395 5555 • Fax +45 6395 5558
post@texas.dk • www.texas.dk