3
9. Remove
VB30 Standards
(A) from floor sockets and lay on floor. Measure the distance from the bottom of
the pole to the bottom of the adjustable foot pad, write it down. Loosen set screw in the collar of the bottom
adjustable foot with the
1/8” Allen Wrench
(D). Turning the adjustable foot clockwise will lower net height,
counter-clockwise will raise net height. Each revolution of the adjustable foot will raise or lower the
VB30
Standard
(A) by approximately 3/16”. Make sure you use full revolutions. The set screw must rest on the
machined flat on the adjustable foot to eliminate damage. Check your math to ensure you have moved the
adjustable foot in the correct direction, tighten the set screw. See Figure 2.
10. Repeat instructions #1-#7. If your adjustments were correct you’re ready to “set and play”. Repeat
instructions #8-#10 if further adjustment is needed.
Once the pole length is initially adjusted to match the
floor sockets no future adjustment should be necessary
.
11. You can make some slight modifications to fine tune the net height by raising and lowering the
Nylon Net
Collars
(J) by tightening/loosening the winch, and by adjusting the tension on the side
Rope Ratchets
(H) if
necessary.
NOTE:
Excessive tightening of top rope is not necessary. Crank the winch until poles start to flex. Further tensioning
results in lowering of the top rope. Achieve proper height using the adjustable foot for adjustments and to
achieve proper net tensioning use the Rope Ratchets (H).
(H)
37' CENTER TO CENTER
APPROX.
42"
TIGHTEN ROPE RATCHET
TENSIONERS SO THAT NET IS
CENTERED BETWEEN THE POLES
Figure 4
Summary of Contents for Lady CarbonMax Series
Page 5: ...5 Court Diagram ...