2
Initial Standard Height
Adjustment
Rope Ratchet (H)
Figure 2
ATTACHMENT HOOK (I)
ROPE GUIDE
VB30 Standard (A)
Figure 3
3. Lay
the
VB1250K Net
(F) out
finding the end with the factory
installed rope ratchet device on the
bottom rope. Install the opposite end
of the net to the non-winch standard
by running the black top rope over
the rope guide and attaching the
loop to the
Attachment Hook
(I).
Attach the other end of the net top
rope to the winch standard by
running
the
black
top rope over the
rope guide and connect it to the 2”
winch
strap
Carabiner
(K).
See Figures 2, 3 and 4.
4. Attach both ends of the net bottom
rope
to
the
Nylon Net Collars
(J)
with
Carabiners
(K). See Figure 4.
5. Turn the winch handle to tighten the
top rope of the system to eliminate
the slack in the rope. Center the net
between
the
two
VB30
Standards
(A). Finish tightening the top rope
using the winch and pull the loose
end of the bottom rope through the
bottom rope ratchet to tighten the
bottom rope. See Figure 4.
6. Install
the
Rope Ratchets
(H) by
running the rope through the small
holes in the sides of the net and
around the pole. Tighten all four
devices evenly to achieve desired
net tension and maintain proper net
placement between the
VB30
Standards
(A). See Figure 4.
7. Measure from the top center of
VB1250K Net
(F) to the floor.
Women’s official height is 7’ 4 1/8”.
If this measurement is above or
below the official height write it
down and proceed to instruction #8.
8. Remove
VB1250K Net
(F) from
VB30 Standards
(A).
Summary of Contents for Lady CarbonMax Series
Page 5: ...5 Court Diagram ...
