Park Audio II GS Series, Owner'S Manual

Page: 12 / 24

REAR PANEL
THROUGH – line outputs (XLR male).
Used to deliver input signal to the input of another amplifier. THROUGH connectors
are parallel to INPUT connectors of respective channels.
GAIN – input sensitivity.
Used to select the input sensitivity (0.775 V, 1.4 V) or a 32 dB fixed gain.
INPUT – Channel 2 balanced input (XLR female).
HI PASS FILTER – cutoff filter switches.
Used to set the required cutoff frequency (35 Hz or 45 Hz) or to disable the filter (See:
Input Filter).
MODE switch:
– MONO – two channels drive two separate loads from a single input signal source;
– STEREO – two channels drive two separate loads from two separate input signal
sources;
– BRIDGE – two channels drive a common load from a single input signal source.
INPUT – Channel 1 balanced input (XLR female).
Used to supply input signal to channel 1, channel 1 and 2 (in MONO mode), and a
common input signal (in BRIDGE mode).
Label.
Contains the amplifier model designation, power ratings and Serial No.
GS 6, GS 7
NLT4M
LIE
CHTENSTE IN
NLT4M
LIE
CHTENSTE IN
GS 4, GS 5
10