Tighten the knobs securely (unscr
. The brush/pad could disengage and cause injury.
with a pipe or bucket. Do not remove the Solution F
ilter (21) while
The machine can be filled
Solution Tank F
illing
(56/57), unscrew the thumb nut (37).
ew the knobs, if disassembling).
slide the squeegee into the slots of the squeegee
ion as indicated in figure 2.
down the squeegee on the “working” position.
Turn off the main switch (47).
Squeegee Installation
Do not turn on the machine in th position shown below
e
WARNING!
locks, as indicated in figure 3.
brackets.
3
3. Mount the brush or pad driver onto the drive wheel hub and then rotate counterclockwise until it
1
．
2
．
Pull down the squeegee lift lever (26) to put
3
．
Lay down the machine in this posit
4
．
Loosen the two knobs (55) on the squeegee and
5
．
To replace the front/rear squeegee
NOTE
Figure
3
Figure
2
hub.
4. To remove the brush/pad, rotate the brush/pad clockwise until it is released from drive wheel
filling.
