SafeAir™ M-600 Installation Guide
23
www.parazero.com
SafeAir M-600 V2 model
12
Using the DJI extension’s arm
switch, arm the system by
flipping it to its activated
position (Up), wait 4 seconds
and then switch it back to its
safe position (Down). Check
that the LED on the SmarAir
turns
GREEN
, and that a long
beep was heard.
13
Wait 3 seconds and then
Disarm the system by
pressing
that same switch up. Verify
that the LED turns
PURPLE
,
(it
will flash and then stay
permanent) and that you hear
a double-beep
.
Now the
system is disarmed.
14
Wait 3 seconds, then turn the
switch down again. See that
the LED turns
BLUE
.
Takeoff
1
After take-off, you must climb to approximately eight meters before the system is
armed. Climb until you hear a single long beep, and the LED is
GREEN
.
2
The system is now armed and ready for activation in case of an emergency.
Optional – manual arming:
Take off to an altitude of at least 3 meters above ground level. Arm the system by
using the DJI extension’s arm switch: switch it up, wait 4 seconds and then switch it
down to its safe position again. Verify that the LED on the SmartAir turns
GREEN
,
followed by a long beep
.
The parachute is now armed and ready to operate
for the first time
Caution
During parachute deployment, the following steps need to be performed in order
to lower the M-600 landing gear.
Using the DJI remote: Pull both sticks towards the center OR use the landing
gear switch to lower the legs.
Both options are fully functional after the flight termination system cuts
the motor power
