PARASIT STUDIO QUANTOM DEFRAKULATOR, Manual, Page: 3 / 7

Parasit Studio
Quantum Defrakulator Bill of Materials
•
* Current Limiting Resistor for the sequencer LED's. They share a
single resistor since there's always just one LED engaged at the
time. Use the appropriate value for your LED type. I recommend
using a 4.7K resistor for a diffused LED or a 15K resistor for a clear
superbright LED.
•
I recommend using multilayer ceramic capacitors to keep the size
down of the 220nF caps. For the larger values use electrolytic
capacitors as usual.
•
For the momentary switch you can use any type of momentary
switch or push button. It can be either normally open or normally
closed, it doesn't matter.
•
If you want to drive this effect from a 9 volt battery, I recommend
using an extra switch (like a SPST or using two pins of a SPDT) as
an on/off switch, to disengage the battery while not in use -
Resistors Capacitors IC's
R1 10K C1 220nF U1 CD4013
R2 2.2K C2 47uF U2 CD4052
R3 CLR* C3 100nF U3 CD40106
R4 1M C4 220nF
R5 10K C5 220nF Potentiometers
R6 10K C6 22nF RATE C50K
R7 100K C7 22uF FILTER C50K
R8 100K C8 100uF Rest of the pots (x9) B100K
R9 100K C9 100nF
Diodes (11 pots total)
D1 1N4001
4x LED's (for the sequencer) Switches
1x optional LFO on/off LED LFO sw Momentary SPST