Parani Parani-SD1100, User Manual

Page: 12 / 48

12
2.5. Reset to Factory Defaults
To set all the configuration settings to its factory default parameters, press the reset button, depicted in
Fig. 3-1. Press and hold (for at least 1 sec) the reset button with a narrow pointed tool like paper clip.
Reset works only when power is on.
2.6. Dipswitch
With the combination of 4 slot dipswitches, RS422/485 select, baud rate 9600 select, 485 echo and
termination on/off control can be set.
ParaniWIN or terminal program should be used to set these speeds. To set a baud rate not shown
below the dipswitches should be in the S/W Config setting. When in the S/W Config setting the baud
rate will go back to 9600 as default.
Table 1 Select by Dipswitches
422 485
Select
Table 2 Termination Select by Dipswitches
Off On
Termination
Table 3 485 Echo Control by Dipswitches
Off On
485 Echo Control
Table 4 Baudrate Settings by Dipswitches
AT Command 9600
Baudrate