26
The machines in this product line were designed and tested to meet the ASTM (American) and EN
(European) safety standards for stability (without floor anchors) when the machine is used for it’s
intended purpose as designated by the manufacturer.
However, Paramount strongly recommends that all equipment be anchored to the floor to prevent
movement and increase stability.
• You will need to order an anchoring kit for each machine. This kit will include brackets and
instructions for securing the brackets to the machines. Note: the kit does not include the
floor anchor bolts. Order part number: FS-BLTDN-000X, 1 kit per FS machine.
• Due to the wide variation of flooring on which the unit can be installed, contact a qualified
contractor to determine an appropriate fastening system for your floor.
• Use 3/8” diameter hardware (10 mm) to anchor the machine. Anchors should have a
minimum pull out force of 220 lbs (110 kgs) for each position.
• When attaching the machine to the floor, if there is a gap between the machine foot (or
bracket) and the floor, do not use the anchor to remove the gap as this can cause the
machine frame to deform. Instead, place a shim between the bottom of the foot and the
floor, then tighten the anchor.
FS B
OLT
D
OWN
I
NSTRUCTIONS
Upright hold down brackets with hardware
(included in kit, qty 2)
Main frame hold down bracket
(included in kit, qty 1)
Re-uses existing machine
hardware. Refer to kit instructions
for details.
Floor Anchor Point
Floor Anchor Point
