DAILY MAINTENANCE
11
<Main unit, plastic basket, name holder>
Note: For parts names, see page 7.
To remove dirt from parts
Complete steps (1) to (3) listed below.
(1) Wipe off parts using a soft cloth soaked in a neutral cleaning solution lightly diluted with water that
has been wrung out to remove excess fluid.
(2) Wring out as much moisture from the cloth as possible and then wipe up any remaining cleaning
solution residue.
(3) Use a dry cloth to thoroughly wipe away any leftover moisture.
If oil or dust is adhering on the slip stopper rubber surface of the basket holder frame, you must wipe it off
to clean the surface.
Disinfecting parts
Use one of the cleaning solutions listed below at the specified concentrations, making sure to follow the
instructions in the manual or other materials available for the cleaning solution.
76.9% - 81.4%
ethanol for disinfection
Up to 0.2%
benzalkonium chloride
Up to 0.2%
benzethonium chloride
Up to 0.05%
chlorhexidine gluconate
Up to 1.0%
sodium hypochlorite
WARNING
Pay attention to the slip stopper rubber status. When the surface of the slip
stopper rubber has deteriorated, the stopper effect is lost and the plastic
basket could slip, possibly causing injury. If the slip stopper effect has
deteriorated, request replacement.
CAUTION
Do not use volatile cleaning fluids (such as paint thinner, benzene or
gasoline) and cresol. Discoloration or deterioration could result.
Do not use cleaning solutions with the
product other than those listed above.
Discoloration or deterioration could
result.
Thoroughly wipe off parts with a damp
cloth after using a neutral cleaning
solution. Not doing so could cause resin
parts to crack.
When cleaning the cart, be careful about corners and the edge of the frame
and screw parts. There is a risk of injury to the hand.
The product cannot be used with an ozone sterilizer, an autoclave, etc.
Additional
products
Be sure to read the instruction manual for each additional product.
N
o
te
!
Slip stopper rubber
(8 locations)
Basket holder frame
