1
2
3
4
5
6
7
1
2
3
4
5
a)
b)
PARAJET VOLUTION 3 PARAMOTOR
OWNERS INSTRUCTION & SAFETY MANUAL
Fitting the Cage Sections
The Volution 3’s super-strong aerofoil
cage offers strength and aerodynamic
styling. The unique cage system consists
of four sections and enables the protective
cage to be put together in seconds,
requiring no tools.
Starting with a lower cage section,
insert the cage dowel into the
mounting aperture located on the
hinge block, making sure the cage
section is curved towards the rear
of the paramotor.
Insert the nylon connector, located
at the end of each leg, into the cage
section. Push the cage section
until the location pin engages and
secures the cage section in position.
4
Repeat the connection procedure
for the second lower cage section.
To fit the top cage section, align the
cage section to the cage dowel and
insert the nylon connector, located
on the top of the chassis, into the
cage section. Push the cage section
until the location pin engages and
secures the cage section in position.
Insert the nylon connector, located
on the outer ring, into the top cage
section. Push the cage section
until the location pin engages and
secures the lower and top cage
sections together.
Repeat the connection procedure
for the second top cage section.
Finally, insert the nylon connector,
located at the top of the outer ring,
into the top cage section. Push the
cage section until the location pin
engages and secures both top cage
sections together.
Propeller Assembly
& Attachment
The propeller for the Volution 3 can rotate
in either a clockwise or anti-clockwise
direction when looking at the paramotor
from the rear. This is crucial when fitting
the propeller to the hub, please check your
engine manual for more information.
Lay the two propeller blades on
the ground while orientating the
blades so that the ‘Parajet’ propeller
stickers are facing upwards (a).
Slide the two propeller blades
together ensuring that the mounting
holes align correctly (b).
Insert the six propeller bolts into the
propeller plate. Align the bolts with
the mounting holes and insert into
the propeller.
Wrap your hand over the top of the
propeller plate and bolts. Picking
up the propeller, align the propeller
bolts to the mounting holes on the
hub.
Tighten the bolts to 10nm in a
diagonal, opposing pattern. Do
NOT over tighten as this can cause
damage to the propeller.
