ASSEMBLY - Dolly Base Configuration
1
. Install either of the boom sections into the dolly
base. Make sure the holes in the corner of the tube
are up.
2
. Tighten both lock screws on the dolly base to hold
the boom tube securely.
3
.
Let out about 2’ loop of str
a
p on the Collar Assembly
and slide the Collar Assembly over the boom tube.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
MAKE SURE
the seat of the Collar Base Assembly is
oriented on the same side as the longer base legs as
shown.
4.
Insert the split boo
m
connector. Align the set
screws
with the access holes in the boom tube.
5
. Fit the second boom section over the split boom
connector. Align the corners access holes with those of
the lower section.
6.
Using the hex key stored on the collar assembly, tighten
both set screws on the split boom connector securely.
7
. Insert the top roller assembly then position the strap
over the top rollers, raising the Collar up the Boom.
Make sure corner
holes are up
Align set screws
with access holes.
6
