Paragon Fires focus rs plus remote, Owner'S Manual

Page: 20 / 28

LT5944 Iss 1 (25/10/11)
20
PARAGON FOCUS RS PLUS Maintenance Instructions
SECTION FOURTEEN Maintenance Instructions
General

Servicing should be carried out annually by a competent person such as a GAS SAFE - registered
person in accordance with the relevant regulations, to ensure the safe and correct operation of the
appliance.
Warning: - Before commencing any service or replacement of parts, turn off the gas supply to
the fire.

After servicing check for gas soundness.

When ordering spare parts please quote appliance name and serial number these can be found
on the data badge, which is located on the appliance remove the decorative fire front for access.

If soot has accumulated check to establish cause, rectify and clean flue accordingly.
Important: -
Refer to ‘Health & Safety Notice (See Page 3) at the front of this
booklet before removing the fuel bed components.

Examine the coals for signs of cracking and replace if necessary.(IMPORTANT) see coal layout
procedure in section four of this manual before attempting to replace coals, which should only be
replaced as a complete set with no extra coals added.

Check pilot aeration holes for linting, use a vacuum cleaner to remove any lint taking care not to
damage the pilot head.
Replacement of Gas Control
1. Remove the fret or fascia and turn off the gas supply ay the isolation cock.
2. Remove the gas control knob
3. Remove the control plate held by 2 screws on the left hand side.
4 Disconnect the injector pipe from the left hand side of the gas control.
5 Disconnect the pilot pipe from the underside of the pilot burner.
9. Pull off the connection to the spark electrode
10. Undo the supply connection to the pressure test elbow.
11. Remove the 2 connections to the micro switch.
12. Remove the two screws holding the gas valve bracket to the casing.
13. Pull the complete assembly forward and remove the thermocouple for the rear of the gas
control.
14. Carefully remove the cam from the spindle of the gas control ensuring you note its correct
orientation on the spindle for later reassembly.
15. Disconnect remaining pipes and bracket from the control.
16. Change or service the valve and replace in reverse order.
17. Turn on the gas supply, check for soundness and re- commission.
Replacement of Injector
1. Remove the fret or fascia and turn off the gas supply ay the isolation cock.
2. Remove the glass and fuel bed components as described earlier in this manual.
3. Undo and remove the 2 screw holding the burner in place
4. Carefully remove the burner lifting from the right hand end of the burner.
5. Loosen and remove the injector back nut.
6. Remove the 4 screw holding the burner support bracket into place and carefully filt away the
burner support bracket avoid putting strain on the injector.
7. Undo the compression connection to the injector and lift it away
Clean or replace injector and replace in reverse order, ensuring that the connection to the
injector fixing is sound air test if in doubt.
8. Turn on the gas supply, check for soundness and re- commission.