21
Configuring SNMP Trap Managers and Trap Dial-Out
Once the iMarc unit is connected to the network, SNMP trap managers, SNMP traps,
and trap dial-out can be configured.
Procedure
1.
Select SNMP Traps.
Main Menu
→
Configuration
→
Management and Communication
→
SNMP Traps
2.
Configure the following:
—
Enable SNMP Traps.
—
Identify the total Number of Trap Managers.
—
Specify the IP address of the NMS(s) to which traps will be sent.
—
Specify the network Destination for the Trap Manager(s).
—
Select desired trap categories.
—
Enable Trap Dial-Out, if desired.
3.
Save the configuration.
4.
Return to the Main Menu.
Connecting to the Network
Procedure
1.
Insert the 8-pin connector on the RJ48C
network cable into the NET interface.
2.
Insert the other end of the cable into the
RJ48C modular jack.
3.
Verify that the Network signal (SIG) LED
is green, and that the Network
out-of-frame (OOF) and alarm (ALM)
LEDs are off. If so, the network interface is set up correctly and is operational. If not,
make sure both ends of the network cable are properly seated.
The FR (Frame Relay) LED is green when the LMI is up and yellow when the LMI is
down.
4.
Check Health and Status messages in the left column of the System and Test
Status screen.
Main Menu
→
Status
→
System and Test Status
If
LMI Down, Network
appears for more than three minutes, or any other
network-related status message appears, refer to the status information in the
iMarc SLV Operations Guide
for possible reasons for the messages and what can
be done to resolve the problem.
If the unit does not have ISDN backup capability, proceed to
Configuring SNMP Trap
Managers and Trap Dial-Out
.
N
E
T
1
D
B
M
M
D
M
D
S
X
SINGLE
T1 NAM
RJ48C
Jack
NET 1
00-16836
E
N
E
T
Summary of Contents for iMarc SLV9128
Page 36: ...36 9128 A2 GN11 70 ...
