Paradyne HOTWIRE 8610 DSLAM, Installation Manual

Page: 32 / 56

2. Installation
2-16
April 2001 8610-A2-GN20-10
Procedure
To install a circuit card in the Hotwire 8610 DSLAM chassis:
1. Remove the filler plate from the slot by unscrewing the mounting screws at
each end.
2. Hold the card horizontally with the components on top, and insert it into the left
and right card guides of the slot of the base chassis.
3. Carefully slide the card into the slot. Gently, but firmly, push the card until it
engages its mating connectors on the backplane.
4. Press on the card’s front panel with one hand and on the back of the
8610 chassis with the other until the card’s connector seats in its mating
connector.
5. Make sure the OK SYSTEM indicator on the card’s faceplate is ON (green). If
not, refer to
Troubleshooting Table
in Chapter 4,
Troubleshooting
.
6. Secure the card by fastening the screws on each end of the faceplate. This is
required to maintain proper gasket pressure on the faceplate as well as proper
air flow.
NOTE:
For detailed information about the configuration and operation of the circuit
card, see the appropriate card User’s Guide.
99-16321-01
TM
TM
STACK
POSITION
2
3
6 5
4
1
AC
INPUT
1
2
3
ESD ESD
48VDC CLASS 2
OR LIMITED
PWR SOURCE
48V
A
RTN
A B B
A B
DC FUSES
T4A, MIN. 48V
PWR
A ALM
FAN
B
OUT IN SERIAL ALM INTF
MCP/1
2 3
MCP/
DSL
MANAGEMENT 10 BASE T
8610
MCP 8000
SYSTEM
OK Alrm Test TX RX Coll
ETHERNET
RADSL
8000
SYSTEM
OK Alr
m
Test TX RX Col 1 2 3 4
ETHERNET
DSL POR
T