496-15149
14
Center-Mounting the 8610 Chassis in a Rack
"
Procedure
To center-mount the 8610 chassis in a rack:
1. Determine the preferred placement of the 8610 chassis in the rack. Then, mark the
appropriate locations for the mounting screws on the rack.
2. Reposition the mounting brackets to the center-mount position using the four #8-32
screws supplied with the chassis.
3. Fasten the chassis to the rack. Insert the screws through the rack and into the two
screw holes located in the center of each side of the chassis.
Repeat these steps for each succeeding 8610 chassis.
Complying with NEBS
The following must be taken into consideration for compliance with Network Equipment-
Building System (NEBS) requirements.
Connection to the CO Ground Lug
"
Procedure
1. Strip back the insulation approximately 1/4- to 3/8-inch on 14 AWG copper wire.
2. Loosen the screw on the GND lug located on the rear surface at the center of the
Hotwire 8610 DSLAM cover.
3. Insert the stripped end of the wire into the open end of the GND lug and tighten the
lug’s screw. Make sure it is making contact with the stripped portion of the wire.
ESD Wrist Strap Jack
A noninsulated banana jack is located at the left front side of the Hotwire 8610 DSLAM
to provide a ground for the ESD wrist strap’s plug.
!
HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from
damage due to electrostatic discharge (ESD) during normal
operation. When performing installation procedures,
however, take proper static control precautions to
prevent damage to equipment. If you are not sure
of the proper static control precautions, contact
your nearest sales or service representative.
