Paradyne HOTWIRE 8310 MVL, User Manual

Page: 86 / 98

Download Code and Apply Download
A-2
8000-A2-GB26-00 May 1998
TFTP Server Configuration
When you are downloading code to an endpoint, configure your TFTP server with
the following timeout values:
H
Retransmission timeout – Value not less than 10 seconds.
H
Total transmission – Value not less than three times the retransmission
timeout.
You may also use the above values for a standard TFTP transfer.
NOTE:
Before initiating a download, verify that you can Ping to the TFTP server. If
you can not, do not proceed with the download. Also, make certain that the
files that you are going to download from exist in the system.
Download Code
When you are attempting to download to the DSL cards, refer to Table 5-1, Card
Status Options , in Chapter 5, 8310 MVL and 8510 DSL Card Configuration. In
general, the following describes what to expect when you have initiated a
download from the configuration menu.
From the DSL Configuration Main Menu, select
Configuration
→
Card Status
→
Download Code (A-A-F).
This selection brings you to the Download submenu. Select Download Code.
NOTE:
To download code to the Service Node(s), you must use the MCC download
menu. For information on this and other methods used to download firmware
to the DSL and MVL cards, see Chapter 4,
Configuration Options, in the
Hotwire Management Communications Controller (MCC) Card, IP
Conservative, User’s Guide.
Fully Functional System: Deferred Apply
Enter the path and image file name and the TFTP Server IP address. Select yes
to begin the file transfer. When you are downloading the new firmware, this does
not impact service or the operation of the system. Depending on the network
traffic, this download may take a minimum of 10 minutes. You may apply the
newly acquired firmware load at any time following the successful transfer.
CAUTION:
When the download is completed, if you elect to apply the code, service
will be disrupted while the card restarts and the new code is installed.