Paradyne Hotwire 6381 Installation Instructions Manual Download Page 19

19

License Agreement

ONCE YOU HAVE READ THIS LICENSE AGREEMENT AND AGREE TO ITS TERMS, YOU MAY USE THE
SOFTWARE AND/OR FIRMWARE INCORPORATED INTO THE PARADYNE PRODUCT. BY USING THE
PARADYNE PRODUCT YOU SHOW YOUR ACCEPTANCE OF THE TERMS OF THIS LICENSE AGREEMENT.

IN THE EVENT THAT YOU DO NOT AGREE WITH ANY OF THE TERMS OF THIS LICENSE AGREEMENT,
PROMPTLY RETURN THE UNUSED PRODUCT IN ITS ORIGINAL PACKAGING AND YOUR SALES RECEIPT
OR INVOICE TO THE LOCATION WHERE YOU OBTAINED THE PARADYNE PRODUCT OR THE LOCATION
FROM WHICH IT WAS SHIPPED TO YOU, AS APPLICABLE, AND YOU WILL RECEIVE A REFUND OR
CREDIT FOR THE PARADYNE PRODUCT PURCHASED BY YOU.

The terms and conditions of this License Agreement (the “Agreement”) will apply to the software and/or firmware 
(individually or collectively the “Software”) incorporated into the Paradyne product (the “Product”) purchased by 
you and any derivatives obtained from the Software, including any copy of either. If you have executed a separate 
written agreement covering the Software supplied to you under this purchase, such separate written agreement 
shall govern.

Paradyne Corporation (“Paradyne”) grants to you, and you (“Licensee”) agree to accept a personal, 
non-transferable, non-exclusive, right (without the right to sublicense) to use the Software, solely as it is intended 
and solely as incorporated in the Product purchased from Paradyne or its authorized distributor or reseller under 
the following terms and conditions:

1. Ownership: The Software is the sole property of Paradyne and/or its licensors. The Licensee acquires no 

title, right or interest in the Software other than the license granted under this Agreement.

2. Licensee shall not use the Software in any country other than the country in which the Product was rightfully 

purchased except upon prior written notice to Paradyne and an agreement in writing to additional terms.

3. The Licensee shall not reverse engineer, decompile or disassemble the Software in whole or in part.

4. The Licensee shall not copy the Software except for a single archival copy.

5. Except for the Product warranty contained in the manual, the Software is provided “AS IS” and in its present 

state and condition and Paradyne makes no other warranty whatsoever with respect to the Product 
purchased by you. THIS AGREEMENT EXPRESSLY EXCLUDES ALL OTHER WARRANTIES, WHETHER 
EXPRESS OR IMPLIED, OR ORAL OR WRITTEN, INCLUDING WITHOUT LIMITATION:

a.

Any warranty that the Software is error-free, will operate uninterrupted in your operating environment, 
or is compatible with any equipment or software configurations; and

b.

ANY AND ALL IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION IMPLIED 
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND 
NON-INFRINGEMENT.

Some states or other jurisdictions do not allow the exclusion of implied warranties on limitations on how long 
an implied warranty lasts, so the above limitations may not apply to you. This warranty gives you specific 
legal rights, and you may also have other rights which vary from one state or jurisdiction to another.

6. IN NO EVENT WILL PARADYNE BE LIABLE TO LICENSEE FOR ANY CONSEQUENTIAL, INCIDENTAL, 

PUNITIVE OR SPECIAL DAMAGES, INCLUDING ANY LOST PROFITS OR LOST SAVINGS, LOSS OF 
BUSINESS INFORMATION OR BUSINESS INTERRUPTION OR OTHER PECUNIARY LOSS ARISING 
OUT OF THE USE OR INABILITY TO USE THE SOFTWARE, WHETHER BASED ON CONTRACT, 
TORT, WARRANTY OR OTHER LEGAL OR EQUITABLE GROUNDS, EVEN IF PARADYNE HAS BEEN 
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, OR FOR ANY CLAIM BY ANY THIRD PARTY.

7. The rights granted under this Agreement may not be assigned, sublicensed or otherwise transferred by the 

Licensee to any third party without the prior written consent of Paradyne.

8. This Agreement and the license granted under this Agreement shall be terminated in the event of breach by 

the Licensee of any provisions of this Agreement. 

9. Upon such termination, the Licensee shall refrain from any further use of the Software and destroy the 

original and all copies of the Software in the possession of Licensee together with all documentation and 
related materials.

10. This Agreement shall be governed by the laws of the State of Florida, without regard to its provisions 

concerning conflicts of laws.

Summary of Contents for Hotwire 6381





















Reviews: