13
As an example, follow these steps to go to the Configuration Edit/Display menu so you
can start setting up the unit.
Procedure
To load a configuration for editing:
1.
From the Main Menu, press the down arrow key twice so the cursor is on
Configuration.
2.
Press Enter to display the Configuration menu. The Load Configuration From menu
appears.
3.
Press Enter to select Current Configuration (the cursor is already on this selection).
The Configuration Edit/Display menu appears.
This sequence of steps would be shown as the menu selection sequence:
Main Menu
→
Configuration
Procedure
To save a configuration option change:
1.
Press Ctrl-a to switch to the function keys area at the bottom of the screen.
2.
Type
s
or
S
(Save) and press Enter. The Save Configuration To menu appears.
3.
Press Enter again to save your changes to the Current Configuration.
4.
Press Esc until the Configuration Edit/Display menu reappears to continue
configuring the unit.
Press Ctrl-a, type
m
(MainMenu), and press Enter to return to the Main Menu.
About the Installation Procedures
There are two methods for installing and setting up the FrameSaver unit.
One person can install and set up the unit. If this is the case, see
Full Installation
and Setup
on page 16
.
An installer can physically install and set up access to the unit, and the network
operation center (NOC) can complete the setup. If this is the case, see
Minimal
Installation
on page 14.
