14
Connecting to the DTE (Router or FRAD)
1. Connect the appropriate cable to the Port (To DTE) connector.
– If the DTE interface type is EIA-530A, the DTE can be directly connected to the
Port (To DTE) connector.
– If the DTE interface type is V.35 or X.21, a V.35 or X.21 adapter cable is
required.
2. Plug the other end of the cable into the DTE.
3. Tighten the screws on each side of the connector to secure them.
00-16678
DTE
4. Check that the Port OK LED is on. If it is, the port is set up correctly and it is
operational. If not, make sure both ends of the cable are properly seated and
secured.
5. Check Health and Status messages in the left column of the System and Test
Status screen for messages.
Main Menu
→
Status
→
System and Test Status
– If
System Operational
appears, the port interface is set up correctly and
is operational.
– If not, refer to Status Information in Operation and Maintenance of the User’s
Guide.
NOTE:
When any error conditions are detected, a status message appears along the
bottom right corner of the screen.
