11
Connecting to the Network
Now that the FrameSaver unit is set up, the unit can be connected to the network.
1. Insert the 8-pin connector of the network cable into the network interface,
NET (S/T).
2. Insert the other end of the cable into the S/T interface of the NT1.
00-16677
NT1
S/T Interface
(ITU-T I.430)
NOTE:
After connecting the network cable, wait about a minute to allow
Auto-Configuration a chance to discover the operating rate and the DLCIs.
3. Check that the Network (NET OK) LED is on. If it is, the network interface is set up
correctly and it is operational. If not, make sure both ends of the network cable are
properly seated.
4. Check Health and Status messages in the left column of the System and Test
Status screen to see the LMI status and verify that LMI is up.
Main Menu
→
Status
→
System and Test Status
If
LMI Down, Net1-FR1
appears for more than three minutes, or any other
network-related status message appears, refer to the status information in
Operation and Maintenance of the User’s Guide for possible reasons.
