3. Configuration
3-50
August 2001
9123-A2-GB20-20
Configuring Telnet and/or FTP Session Support
Telnet and FTP options control whether a Telnet or FTP (File Transport Protocol)
session is allowed through an interconnected IP network and the access security
applicable to the session. Two Telnet sessions can be active at a time (see
Table 3-12, Telnet and FTP Session Options
).
Main Menu
→
Configuration
→
Management and Communication
→
Telnet and FTP Session
When a TS Access Management Link has been set up and activated, the following
options have no effect upon the PVC:
Telnet Login Required
Session Access Level
FTP Login Required
Name 2 Access
Possible Settings: Read, Read/Write
Default Setting: Read
Specifies the type of access allowed to the objects in the MIB. This is the type of access
allowed for external SNMP managers accessing MIB objects using Community Name 2.
Read – Allows read-only access (SNMP Get command). This includes all objects
specified as either read-only or read/write in the MIB RFCs.
Read/Write – Allows read and write access (SNMP get and set commands).
Table 3-11. General SNMP Management Options (2 of 2)
Table 3-12. Telnet and FTP Session Options (1 of 3)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies whether the FrameSaver unit will respond to a session request from a Telnet
client on an interconnected IP network.
Enable – Allows Telnet sessions between the FrameSaver unit and Telnet client.
Disable – Does not allow Telnet sessions.
Telnet Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether a user ID and password (referred to as the login) are required to access
the menu-driven user interface via a Telnet session. If required, the login used is the same
login used for an menu-driven user interface session. This option does not affect the TS
Access Management Link.
Enable – Requires a login to access a Telnet session.
Disable – Does not require a login.
Summary of Contents for FrameSaver FLEX 9123
