3. CLI Commands
CLI-A2-GB20-00
October 2004
3-17
Installation Instructions to obtain specific speed vs. distance capabilities and the
default speed settings for each model. When configuring bandwidth, speed must
be expressed in kbps and entered as a whole number followed by a "k".
Default: varies
Show Commands
A Show command returns the current configuration of a requested parameter as
identified by slot number, port number and/or parameter name. Enter Show
commands as you would Set commands: simply replace the word Set with the
word Show and exclude configuration values from the end of the command. The
following parameter configurations can be requested with a Show command:
Show Command Example
A request for the current speed configuration of all ports in Slot 5 of an IPD12000
would be entered as follows:
[system name] ->SET SLOT [ALL or 1-12 for the IPD12000, ALL or 1-4
for the IPD4000, 1 for the Micro DSLAM] PORT [ALL or port number]
SPEED [xxxxk, OFF]
Example: [system name] ->set slot 2 port all speed 528k
Backbone-VLAN
Inband Management
Speed
CLI Session Timeout
Inband MGMT VLAN ID Subnet Mask
Default Gateway
IP Address
System Name
Firmware Version
Priority
VLAN Range
Flood
SDSL Line Coding
[system name] ->SHOW SLOT [ALL or 1-12 for the IPD12000, ALL or
1-4 for the IPD4000, 1 for the Micro DSLAM] PORT [ALL or port number]
SPEED
Example: [system name] ->show slot 5 port all speed
