17
4
–
Delays and Tones
This menu allows you to set entry / exit
times as well as associated sounds for the
Marine Magellan. Below are the definitions
of the different functions within this menu.
Select
“
ok
”
to go into the
Delays and Tones menu
Entry Delay 1
–
The entry delay 1 is the
amount of time that the user has to disarm
the Marine Magellan system from an armed
state. It is engaged whenever a
“
delay 1
”
zone is opened (see 6 - zone profile). By
default it is 45 seconds. After the time delay
screen you can change the entry tone that
you will hear.
Entry Delay 2
–
This entry delay is identical
to the first except it is engaged whenever a
delay 2 zone opens (see 6 - zone profile).
Exit Delay
–
The Exit Delay determines the
amount of time a user has to leave the
protected area before the Marine Magellan
arms the system. The Exit Delay applies to
all zones (except 24 Hr zones) in the
system.
Bell Cutoff Delay
–
This is the amount of
time that the Marine Magellan will sound its
internal sirens during an alarm event. The
system will stay in alarm after this time is up.
However the Bell cutoff delay will reinitialize
if a zone is opened again. The default bell
cut-off delay is 4 minutes.
Bell Squawk
–
This feature enables the siren
to squawk once
upon arming with a remote control and twice
upon disarming with a remote control.
5
–
System Test
This feature allows you to test all the
different functions of the system to check for
proper operation. Simply select the entity
that you wish to check (zones, outputs,
remotes, etc) and trigger them. The Marine
Magellan will announce the event and
confirm proper operation.
Press
“
ok
”
to begin system test
Summary of Contents for Marine Magel 6130
