24
•
Single Side Burner Assembly
GS-SB1 Single Side Burner Operator Manual
Do not insert a tool or foreign object into any gas valve, which could
cause damage and cause a leak. Leaking propane may result in
explosion, fire, severe personal injury, or death.
When the burner unit is not in use, completely turn off the gas supply
at the LP gas cylinder.
Never store the burner unit indoors with the LP gas cylinder
connected. Always disconnect and remove the LP gas cylinder from
the burner unit before storing the burner unit indoors.
3.
Ensure all burner unit control valves are in the OFF position
4.
Turn the LP cylinder OFF by turning the hand wheel clockwise until it stops
5.
Remove the safety cap from the LP cylinder valve (below left)
6.
Insert the regulator nipple into the LP cylinder valve – keep the regulator in line with the LP cylinder
valve to avoid cross-threading (below right)
Figure 15 LP Cylinder Connection
7.
Rotate the regulator coupler nut clockwise until you meet resistance, then tighten another 1/2 to
3/4 turn. Tighten by hand only – do not use any tools
8.
If the cylinder connection cannot be completed, disconnect the regulator and try again; if the
connection still cannot be made, do not use this regulator and obtain a replacement regulator
9.
Lift the burner unit as needed to gain access to the regulator and gas connection point in the rear
10.
To disconnect the LP gas tank, turn off the main cylinder valve; rotate the black coupling nut
counterclockwise until disengaged