Paradigm GO10SW, Owner'S Manual, Page: 9 / 28

8 EN |
Mono Setup Using 4 Conductor Burial Cable & Crown Amplifier
Preparing the 4 Conductor Burial Cable
WIRING & SUBWOOFER INSTALLATION
1 . Starting
with the first
speaker and
every speaker/
sub that
comes after,
create a loop
approximately
6” in length .
3 . Use a Round
Cable Stripper
to remove the
outside protective
cable jacket to
expose the four
color-coded
wires . Separate
the wire loops
as shown .
2 . Recommended:
Use a wire tie
(not included)
to keep the wire
loop intact and
act as a strain
relief .
Wires for
Subwoofer
white (+) &
green (-)
Wires for
Speaker
red (+) &
black (-)
Mono Mono Mono Mono Mono Mono
GOSW12
GOSW10
OR
NOTE: If using 4 conductor
burial cable, cap any loose
wires at the the last speaker
installed to avoid short out and
potential amplifier damage .
4 . Cut the white (+)
and green (-)
wires with cable
strippers and
strip off 1 inch
(25 .4mm) of
insulation from
the ends of the
wires to expose
the copper
conductor .