6
2. Connecting
You are now ready to connect and install the speaker.
Connecting (Fig. 5a) (all models except those with ‘SM’ in their name, see below).
Connect the speaker cable. Correct polarity, or phase is critical for proper stereo
imaging and bass performance.
Connect the red (+) amplifier terminal to the red (+) speaker terminal. Connect
the black (-) amplifier terminal to the black (-) speaker terminal. Fasten cable to
bracket with wire tie.
Connecting P80-SM Model:
Two Speakers (Fig. 5b): Connect one speaker at a a time to the left and right
channels of your receiver/amplifier as per the diagram.
IMPORTANT! BEFORE MAKING WIRING CONNECTIONS, position
the switch to the MONO position.
One Speaker (Fig. 5c): Connect one speaker channel at a time to your
receiver/amplifier as per the diagram.
IMPORTANT! BEFORE MAKING WIRING CONNECTIONS, position
the switch to the STEREO position.
3. Installing the Speaker
IMPORTANT! While it is possible to use a manual screwdriver for installation, we
strongly suggest using a power drill. To avoid damaging or breaking the clamps,
set your drill to a LOW setting. A high power setting is NOT necessary and may
cause clamps to crack or break from the added force. Such damage is NOT covered
under warranty.
1) Set your Power Drill to the Low setting.
2) Ensure the clamps on the lip of the speaker are positioned exactly as shown
in the Warning Diagrams on the top of page 9 and 10. If they are not correctly
positioned, refer to these diagrams.
3) Gently push the assembly into the ceiling or wall hole (Fig. 3c or 4d).
4) Supporting the assembly with one hand, tighten each screw (Fig. 3d or 4e).
Stop tightening when you sense resistance.
Model with Guided Soundfield
™
(P80-A, E80-A): Rotate speaker at this point
so that drive assembly points in the desired direction (not shown).
4. Installing the Grille
1) Gently press the grille onto the front face of the speaker (Fig. 3e or 4f). The
magnets will ensure correct attachment.
2) Add the Paradigm logo, if desired.
Summary of Contents for CI PRO Series
Page 1: ...MAN0105...
Page 11: ...10 In Wall Mounting Fig 4e Fig 4c Fig 4a Fig 4f Fig 4d Fig 4b...
Page 14: ...NOTES...
Page 15: ...MD...
