7
STEP 3:
FIGURE 3
•
Insert one 1-3/4” END CAP (12) into the end of the ADJUSTABLE SLIDE (2) as shown in FIGURE 3.
• Attach eight 3/4 X 1-1/2” GLIDES (28) to the inside of the ADJUSTABLE SLEEVE (3) as shown in FIGURE 3 using the
following steps:
• Thoroughly clean all surfaces where the 3/4 X 1-1/2” GLIDES (28) are to be attached.
• Remove the 3/4 X 1-1/2” GLIDES (28) from the paper backing and firmly apply them to all shown surfaces.
•
SECURELY
assemble one SPRING PIN ASSEMBLY (11) to the spring pin barrel on the ADJUSTABLE SLEEVE (3). See FIGURE 3.
•
Pull back on the SPRING PIN (11) and
CAREFULLY
insert the ADJUSTABLE SLIDE (2) into the ADJUSTABLE SLEEVE (3) as shown
in FIGURE 3.
•
Assemble the ADUSTABLE SLEEVE (3) to the BENCH FRAME (1) using one 1/2 X 3-3/4” BOLT (21), two 1/2” FLANGE SPACERS (27),
and one 1/2” LOW HEIGHT LOCK NUT (24) as shown in FIGURE 3.
1/2 X 3-3/4” 21
24 1/2” LOW HEIGHT
27
27
11
2
28
12
1
3
