FIGURE 22
15
10
18
FIGURE 21
18
STEP 21
• Slide the WOLFF SLEEVE (2) over the FRAME SUPPORT (1).
(NOTE: Make sure the spring pin barrel is facing as shown in FIGURE
21.)
• Securely assemb1e one 3/8” SPRING PIN ASSEMBLY (71) and one THUMBSCREW (95) to the WOLFF SLEEVE (2).
STEP 22
• Attach two 2 X 16-1/2” PLATES (18) to the FRAME SUPPORT (1) using one 1/2 X 5-1/2” BOLT (47), and one 1/2” LOW HEIGHT
LOCKNUT (50) as shown on FIGURE 22.
(NOTE:
Securely tighten, then back nut off 1/4 turn to allow the 2 X 16-1/2” PLATES (18) to
rotate freely.)
• Securely fasten the LEG SUPPORT (15) to the BASE (10) using two 1/2 X 3” BOLTS (42), two 1/2” WASHERS (52) and two 1/2”
LOCKNUTS (49).
• Slide one 1/2” DIA U-PIN (55) through the bushing in the WOLFF SLEEVE (2) then force one 1/2” PAL NUT (54) over end of 1/
2” DIA U-PIN (55).
2
71
1
54
55
50
42 1/2 X 3”
1/2” LOW
HEIGHT
50
47 1/2 X 5-1/2”
1
• Securely attach FRAME SUPPORT (1) to the LEG SUPPORT (15) using one 1/2” X 3” BOLT (42) and one 1/2” LOW HEIGHT LOCKNUT
(50) as shown in FIGURE 22.
95
52
1/2” LOW
HEIGHT
49
1/2 X 3” 42
