12
PHYSIO-PORT / PHYSIO-PORT AS
A8136 Revision A
Application, Safety Information
2
Controls and Indicators
Fig. 2-1
Controls and indicators of
PHYSIO-PORT and PHYSIO-PORT AS
Fig. 2-2
Nameplates of the devices PHYSIO-PORT
and PHYSIO-PORT AS
1
Connection for blood pressure cuff
2
Liquid crystal display (LCD)
3
Button
4
Button
5
Button
6
Nameplate
7
Calibration mark
8
Port for connection to PC (USB) at the rear of
the device
9
On/off switch
10
Lid covering battery compartment
Button Functions
During a long-term measurement the buttons on the
device have the following functions:
To start and stop a measurement and to
confirm entries
To display the most recent measurement
values or error message. Systolic value
„S“, diastolic value „D“ and pulse rate
„HR“ are displayed successively.
To mark an event, push the info button
while the measured values are being
displayed. As confirmation, “1111” will be
shown on the LCD display. The related
measurement will be marked in the
measurement value table.
To manually switch the measure interval
between the day phase and the night phase
(see section „ Toggling Between Day and
Night Phase “)
Note
The manual switching between day and night
phases is only possible if two measure intervals
were programmed when the PHYSIO-PORT
device was started with the PhysioPortWin
software and the day/night button has not been
deactivated.
If more or less than two measure intervals have
been set, the day/night button does not have an
influence on the measure intervals.
1
3
4
5
2
6
7
10
9
8
