8) Continue with the other side and hold part 2 against the
chassis tube.
9) Mount part 3 on top of the first part.
10) Add the distances (5) and part 4, make sure the chamfer is
facing out from the chassis. Place the rear axle and line it up
against the chamfer.
11) Place the attachment (1) and mount the screws through all
parts. The long screws on the outside, against the rearwheels.
Tighten all 4 screws slightly with allen key 4 mm.
12) Adjust the rear axle to desired
setting ”A” (COG).
Use a ruler or similar.
Importans to get the same measures
on both sides. Standard is 60 mm on
a S3 but vary depending on model.
13) Tighten all 8 screws firmly with allen key 4 mm.
Done!