PANTHERA MOTORSPORTS
YZ250-YZ250X Electric starter - Installation guide
Run the wiring loom between the airbox and under the chassis shock tower. The plastic of the airbox if
often very sharp, it is suggested to file the sharp edge of the plastic to ensure wires
don’t get cut over
time.
Run the wires along the frame and secure with zip ties. The two power cables (black and red) are to
follow down the clutch cable towards the starter cover.
Install the starter button to the handlebars with the supplied camp and connect to the harness.
Panthera stator installation (for starter kit with charging system)
Place the new stator inside the casing and ensure the that rubber boot is properly sliding in its location.
Proper seat of the rubber is important as the starter housing will contain oil.
Bolt the stator in place with the 3 supplied button head screws using an allen 4mm drive bit. Make sure
the timing mark is aligned and torque to 70 in-lb.
