Principle of its function
The Wall Spreader is a telescopic spanning system, which is able to withstands
heavy loads. By spanning the Wall Spreader between two solid walls, the telescopic
poles form an arch. This arch points upwards, allowing it to be able to take
considerable loads, similar to a bridge.
Note
Before using the Wall Spreader it is essential that the stability and the capacity
of the wall or pillar to withstand pressure be tested! The system is not to be
used on plaster board, insulating or hollow walls. Only limited use on smooth
or slippery surfaces!
Example: Horizontal installation
1.
Make a rough estimate of the spanning distance and begin assembly on the
floor. Be careful while doing, so that objects do not get hit and injury is not
coursed!
2.
Pull out the inside tube to the desired length and place a clamping ring where
the inside tube joins to prevent them sliding into one another. (A minimum of
140mm/5.5´´ should be allowed). The red marking at the end of the inside tube
should not be visible as the load capacity of the system is not assured!
mind.140 mm
5.5 inches
red marking
outside tube
clamping ring
inside tube
3
