BA_PH_335-20_EN_07-22.docx
12
4
Safety
4.1
Basic Safety Instructions
Woodworking machines can be dangerous if used improperly. Therefore, observe the safety instructions listed
in this chapter and the accident prevention regulations of your employer's liability insurance association!
The manufacturer accepts no liability for damage and malfunctions resulting from failure
to observe these operating instructions.
4.1.1
Application Area and Intended Use
The machine is used exclusively for surface planing and jointing of solid wood (soft and hard
woods) as well as plastics and wood-containing board materials.
This machine is not suitable for processing metal or scrap wood - which could contain nails,
screws and other metal parts.
The machine may only be operated on a firm, level surface with a minimum load-bearing
capacity of 1,000 kg/m².
Any processing of other materials requires prior consultation with and approval of the manufacturer.
Improper use can lead to danger to persons and to a defect or damage to the machine.
Only the manufacturer's original planing cutter-blocks and replacement knifes according to
EN 847-1 are permitted as tools. These must be marked with MAN!
Processing type
Length
Height
Width
Surface planing
5500 mm
75 mm
410 / 510 / 630 mm
Jointing
5500 mm
1000 mm
100 mm
The machine is not suitable for operation outdoors or in potentially explosive areas.
•
Permissible ambient temperature: +5 … +40° C.
•
Permissible humidity: 30 … 90 %.
Intended use also includes the connection of the machine to an adequately dimensioned extraction system and
compliance with the operating, maintenance and servicing conditions specified in the operating manual.
Any other use is not in accordance with the intended use and is therefore prohibited.
4.1.2
Modifications and Conversions to the Machine
Unauthorised conversions and modifications to the machine are strictly prohibited for safety
reasons. This will invalidate the CE declaration of conformity! The manufacturer is not liable
for any resulting damage. The risk for this is borne exclusively by the operator/user.
