Polar Bear East/West 10 Degree Installation Manual
9910022 Rev A
22
Multi-piece Claw (Claw III)
The Multi-piece Claw is used when the PV module specified
does not allow short-side PV frame flange mounting. For
proper attachment, place a Claw over the module frame
flange on the long side of the module; slide to the corner, and
tighten the 3/8-16 x 1.25” 18-8 hex head cap screw between
18 and 20 ft-lb (24.4-27.1 N-m). Ensure that the “C” shaped
portion of the Claw is seated up against the flange on the
long side of the module and that the “L” shaped piece of the
Claw is seated over the module frame, with the tab flush
against the short side of the module as shown in the image
below.
Figure 21 Multi-piece Claw Detail
Contact PanelClaw Customer Technical Support for additional information about alternative Claws.
