www.panel.it 24
24
5.3 Motherboard jumpers setup
The system is delivered with the optimized defaults preconfigured state and is operational.
Changes in the jumpers settings may only be implemented by appropriately trained staff.
The illustration shows how jumpers are setup. When the jumper cap is placed on pins,
the jumper is “Short”. If no jumper
cap is
placed on pins, the jumper is “Open”. The il
lustration shows a 3-pin jumper whose pin1 and pin2 are
“Short” w
hen
jumper cap is placed on these 2 pins.
Jumper N°14 of the motherboard
CLEAR CMOS
CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system parameters to default setup, please
turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper
cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you
update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system
first, and then shut it down before you do the clear-CMOS action. Please be noted that the password, date, time, user
default profile and MAC address will be cleared only if the CMOS battery is removed.
Default PSR110-FM factory setting: 1-2
