© Panduit Corp. 2018
OPERATION MANUAL
ENGLISH
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
PA27647A01_05
Page: 61 of 64
12-2018
When first accessing the Network and Setting pages on the PAT SYSTEM; or after approximately
30 minutes of inactivity, entry of a Username and Password is required. The default Username is
“Panduit PAT” and the default Password is ”password”.
15B: NETWORK STATUS
PAT Web Browser Interface
Module
Network
Settings
Network Status
Connected
Device Name
Panduit PAT
CHANGE
Network Settings
DHCP
CHANGE
IP Address
192.168.1.123
Network Mask
255.255.255.0
Gateway IP
192.168.1.99
See
Username and Password
on Page 60 for username and password authentication.
The Network Status indicates the state of the Ethernet/IP connection. A table of Network
Status states is below.
Summary
Requirement
No Power, No IP
address
The device is powered off, or is powered on but with no IP address
configured (Interface Configuration attribute of the TCP/IP Interface
Object).
No Connections
An IP address is configured, but no CIP connections are established,
and an Exclusive Owner Connection has not timed out.
Standby
At least one CIP connection (any transport class) is established, and
an Exclusive Owner Connection has not timed out.
Connection
Timeout
An Exclusive Owner Connection for which this device is the target has
timed out, the network status indicator shall return to steady green
only when all timed out Exclusive Owner connections are
reestablished.
Devices that support a single Exclusive Owner Connection shall
transition to steady green when subsequent Exclusive Owner
Connections are established
Timeout of connections other than Exclusive Owner Connections shall
not cause the indicator to flash red.
The Flashing Red state applies to target connections only. Originators
and CIP Routers shall not enter this state when an originated or routed
CIP connection times out.
Duplicate IP
For devices that support duplicate IP address detection, the device
has detected that (at least one of) its IP addresses are already in use.
Self-Test
The device is performing its power-on self-test (POST); During POST
the network status indicator shall alternate flashing green and red.
Summary of Contents for PAT1M4.0
Page 2: ......
