INSTRUCTIONS CM336
For Technical Support: www.panduit.com/resources/install_maintain.asp
Step 4: Horizontal Cabling and Patch Panel Installation
4.4
T
AK
-T
APE
Location
4.2
PRBR3
Conduit
Knockout
4.1 Route horizontal cable from work area to the enclosure by way
of conduit, raceway (TG-70 or T-70), or through the cable brea-
kouts on the back wall of enclosure. Use supplied edge grom-
met to protect cables from sharp metal edges of raceway
knockouts and cable breakouts. Be sure to allow enough slack
to route and terminate cable.
4.2 With Patch Panel Bracket in up the position, install patch pan-
els (suggested PANDUIT Part No. CPPL24WBL sold sepa-
rately) along with PRBR3 bend radius posts to the front side of
the bracket. (See figure 4.2)
4.3 Rotate Patch Panel Bracket down by twisting latches to release
bracket. Terminate cables with M
INI
-C
OM
G
IGA
-TX style jack
modules (sold separately). Snap modules into patch panels.
Punchdown Patch Panels can also be used.
4.4 Secure cables to bracket arm and back wall using supplied
T
AK
-T
YS
(See figure 4.4).
4.5 Rotate bracket into up position and rotate latches to hold
bracket in place (See figure 4.5)
.
Latches
4.5
T
AK
-T
APE
Location
5.1 Remove perforated panel
5.2 Identify the number of control systems to be mounted (e.g. access control,
lighting, HVAC, etc.).
Note: Do not exceed 50 watts without a fan or 180 watts with fan.
22.5
31.9
Step 5: Control System Mounting
Page 4 of 6
