Page: 11 of 14
MEHT
OPERATION INSTRUCTIONS
Punching Cable Tie Slot in Labels
You can punch a cable tie slot in one or both
ends of the label, then label can be attached
using ties. Cable tie slot accommodates
PANDUIT
stainless steel ties:
•
MLT-S: .18" width (4.6mm)
•
MLT-LH: .25" width (6.4mm)
•
MLT-H: .31" width (7.9mm)
1.
Insert one end of the cut label into the
cable tie slot (K) with the letters facing
down. The letters must face down to
ensure the bridge of the slot is on the
same side of the label as the characters.
I
K
