INSTALLATION INSTRUCTIONS CM296A
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 4 of 5
6A
(Previously installed cables removed from view for clarity)
Base
Door
10 AWG
Ground Cable
Incoming
Ground Cable
6.1 Connect the incoming ground cable to the ground stud
on the base of the enclosure. Use the remaining
adhesive mounts to manage and secure the hot wire,
neutral wire and incoming ground cable to the inner
panel.
6.2 Using one of the supplied 10 AWG Grounding Cables,
attach one end to the grounding stud on the base, on
top of the incoming ground, and the other end to the
grounding stud on the door.
6.3 A second 10 AWG Grounding Cable is to be attached to
the grounding stud on the base, on top of the other two
cables, and the other end will be secured to the inner
panel as shown in Figure 6B.
6.4 Secure the cable ends to the grounding studs on the
base and the door using the supplied #10 Spring Lock
Washers and #10-32 Hex Nuts.
6.5 The third 10 AWG Grounding Cable is to be attached to
the grounding position on the switch and the other end
will be secured to the inner panel.
6.6 The 12 AWG Grounding Cable is to be attached to the
power supply and the inner panel. The end without a
terminal should be attached to the power supply. Refer
to the power supply instruction sheet for proper wiring
techniques and safety.
6.7 Secure the three grounding cables (base, switch and
power supply) to the inner panel using the supplied
#10-32 x 1/2" Pan Head Screw and #10 Spring Lock
Washer.
Step 6: Grounding Cable Installation
6B
10 AWG
Ground
Cable
Inner Panel
12 AWG
Ground
Cable
10 AWG
Ground
Cable
Secure
Cables
Here
