For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2010
FS012
FAPs
(12) capacity
FOSM Fiber Optic Splice Module Installation
Place FOSM Holder over #10-32 studs on
sliding tray (note orientation). Secure with
#10-32 hex nut. Place first FOSM on top of
FOSM Holder (note orientation). The
remaining FOSMs are stacked on top of each
other and snap in place after termination of
lower tray.
Position FAPs between upright flanges as
shown. Once mounted, fully seat NyLatches
to secure FAPs.
Fully extend tray to ensure proper amount of
slack is used.
Finish splicing in each FOSM before adding or
stacking subsequent FOSMs.
Isometric view showing tray fully
open and tilted down.
(cables omitted for clarity)
Figure 8A
FOSM (12)
capacity
FOSM Holder
(Panduit Part No.
FOSMH4U)
Page 8 of 10
