CT-2600 and CT-2600/E
CT-2600 & CT-2600/E
PA26001A01_02
Page: 9 of 11
5-2009
DIE CLOSURE INSPECTION: CT-2600 AND CT-2600/E
Die Closure inspection is made by using the GO/NO-GO gaging dimensions listed in Fig. 6.
TO PERFORM DIE CLOSURE INSPECTION
A.
Clean die and plug gage surfaces.
B.
With crimp dies properly installed in crimp head, slowly activate tool until dies bottom
under light pressure.
C.
Using the proper gage member, insert the GO side into the die – it must pass
completely through the closure.
D.
Reverse the gage and try to insert the NO-GO side into the die closure (Do Not use
excessive force). The NO-GO side may partially enter the die closure but must not
pass completely through.
E.
If both the GO and NO-GO conditions are met; the tool is dimensionally correct.
F.
If the above procedure fails to satisfy all GO and NO-GO conditions, contact your local
PANDUIT
Sales Office.
Fig. 5
Fig. 6
CRIMP
DIE
JAW CLOSURE
DIMENSIONS
PIN GAGE DIA. in. (mm)
GAGE ELEMENT DIAMETERS
in. (mm)
GO “G”
NO-GO “NG”
CD-2600-P8
.148 - .154 (3.759 – 3.911)
.1480 - .1483
(3.7592 – 3.7668)
.1537 - .1540
(3.9039 – 3.9116)
CD-2600-P6
.194 - .200 (4.927 – 5.080)
.1940 - .1943
(4.9276 – 4.9352)
.1997 - .2000
(5.0723 – 5.0800)
CD-2600-P4
.220 - .226 (5.588 – 5.740)
.2200 - .2203
(5.5880 – 5.5956)
.2257 - .2260
(5.7327 – 5.7404)
CD-2600-P2
.315 - .321 (8.001 – 8.153)
.3150 - .3153
(8.0010 – 8.0086)
.3207 - .3210
(8.1457 – 8.1534)
CD-2600-PV8
.188 - .194 (4.775 – 4.927)
.1880 - .1883
(4.7752 – 4.7828)
.1937 - .1940
(4.9199 – 4.9276)
CD-2600-PV6
.228 - .234 (5.791 – 5.943)
.2280 - .2283
(5.7912 – 5.7988)
.2337 - .2340
(5.9359 – 5.9436)
CD-2600-PV4
.315 - .321 (8.001 – 8.153)
.3150 - .3153
(8.0010 – 8.0086)
.3207 - .3210
(8.1457 – 8.1534)
CD-2600-PV2
.355 – .361 (9.017 – 9.169)
.3550 - .3553
(9.0170 – 9.0246)
.3607 - .3610
(9.1617 – 9.1694)
