Panduit ATLONA AT-UHD-CAT-8, Manual

Page: 12 / 47

AT-UHD-CAT-8 12
Installation
IP Configuration
The AT-UHD-CAT-8 is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available),
will automatically assign an IP address to the unit. Use an IP scanner, along with the MAC address on the back of
the unit, to identify both the unit and its IP address on the network. If a static IP address is desired, the unit can be
switched to static IP mode. Use one of the following procedures to switch between DHCP and static IP mode.
The default static IP address of the AT-UHD-CAT-8 is 192.168.1.254 .
If the AT-UHD-CAT-8 is unable to detect a DHCP server within 15 seconds, then the unit will set all IP settings to zero.
AT-UHD-CAT-8
HDMI
OUT IN
HDBaseT
4 3 2 1 8 7 6 5
POWER EDID
LEARN INT LOCK
1 2 4
HDMI
IN OUT
HDBaseT OUT
3 5 6 8 7
DC 48V IN
FW
LAN
MASTER 1 RS-232 IR
TX RX TX RX
2 RS-232 IR
TX RX TX RX
3 RS-232 IR
TX RX TX RX
4 RS-232 IR
TX RX TX RX
5 RS-232 IR
TX RX TX RX
6 RS-232 IR
TX RX TX RX
7 RS-232 IR
TX RX TX RX
8 RS-232 IR
TX RX TX RX
RS-232 IR
TX RX TX RX
LOCK LED indicator
IMPORTANT: If the AT-UHD-CAT-8 is receiving a DHCP IP address, and the IP mode is changed to
static, then Telnet and web GUI communication will be lost.
1. Make sure the AT-UHD-CAT-8 is powered.
2. Connect an Ethernet cable between the LAN port of the AT-UHD-CAT-8 and the Local Area Network (LAN).
3. Press and hold the POWER button for approximately 15 seconds. Release the POWER button once the LOCK
LED indicator begins to flash. The number of flashes will indicate the currently selected IP mode.
POWER button flashes Description
Two Static IP mode IP address: 192.168.1.254
Netmask: 255.255.0.0
Gateway: 192.168.1.1
Four DHCP mode
Setting the IP Mode
Use the IPStatic and IPDHCP commands to switch between DHCP and IP mode through RS-232 or Telnet. Refer to
API documentation for more information. All commands and their arguments are case-sensitive.
• Setting static IP mode
1. Connect to the AT-UHD-CAT-8 using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the
off
argument, as shown.
IPDHCP off
Setting the IP Address Using Commands
IMPORTANT: Note that when switching between DHCP and static modes, within a Telnet session,
the connection will be terminated once the IPDHCP command is executed.